Menu

Topics

© 2012 BlogName - All rights reserved.

Firstyme WordPress Theme.
Designed by Charlie Asemota.

Ranger 96 Problem after Rebuild

September 12, 2014 - Author: bartbarton - No Comments

I have a Ford Ranger 1996 4.0L  OHV 4WD

Question:   I have a M5R1 5 speed that was making noise and a little hard to shift but worked ok. I pulled it and replaced bearings, seals, and synchronizers. The 5th and reverse slider teeth were worn on the tips so I replaced that slider. It works shifts and sounds good. But it now will jump out of 5th gear. I was sure I put that slider in correctly, the dot to the rear of trans, but wandering what else it could be? Would appreciate some advise.

Answer: From you description of the problem we suspect that the 5th gear engagement teeth are worn..you will need the following part:

  • MWTF1TZ-7158B-R 5th gear (counter shaft) your cost is $72.80 plus S&H.

Give Scott a call 888-824-2012 he can help you.  You can see the other parts we can supply for the M5R1 on our website.

Categories: M5R1 M5R2

Leave a Reply

Your email address will not be published. Required fields are marked *